Search / Ordering
The AS5145B Eval-Kit is designed to adapt standard size stepper motors with a contactless rotary position sensor. Rotation of the magnet holders is sensed by the rotary position sensor, soldered on the PCB board.
The AS5145 is a contact less magnetic rotary encoder for accurate angular measurement over a full turn of 360 degrees.
It is a system-on-chip, combining integra…
The AS5048 Eval-Kit is designed to adapt standard size stepper motors with a contactless rotary position sensor. Rotation of the magnet holders is sensed by the rotary position sensor, soldered on the PCB board.
The AS5048 is an easy to use 360° angle position sensor with a 14-bit high resolution output. The maximum system accuracy is 0.05° assuming linearization and averaging is do…
This design provides a complete solution for pH sensor with temperature compensation. The circuit has three critical stages: the pH probe buffer, the ADC, and the digital and power isolator.View Design
The MAXREFDES117# reference design is a low power, optical heart-rate module complete with integrated red and IR LEDs, and a power supply.View Design
The LDC10xx Evaluation Module is designed to provide an example LC tank and coil structure application which interfaces to a host computer. The module can be used independently of the GUI by the on-board embedded LED, which demonstrates threshold detection.
The EVM includes an example PCB sensor which is a 2 layer, 23 turn, 14mm diameter inductor with a 100pF 1% NP0 capacitor connect…
Building off Lattice’s broad support for bridging image sensors to parallel buses for ISP (Image Signal Processors), Lattice has designed a new sensor interface board. There are two purposes for the MachXO2™ Dual Sensor Interface Board (DSIB). First, the DSIB confirms that sensor bridges can be implemented in the low cost MachXO2 device. Second, the DSIB platform demonstrates two image sensors be…View Design
The AS5048A evaluation kit is designed to adapt standard size stepper motors with a contactless rotary position sensor for easy and fast evaluation of the IC in the application. The evaluation kit includes the PCB with soldered IC, 4 magnet holders with different shaft diameters and the allen key. The 4 distance bolts and the motor are not included. On the connector you get the SPI Serial Periphe…View Design
Application note SLAA283 from Texas Instruments was used to create MSP430-PIR, there are a few differences between the TI schematic and ours - our schematic support both the TI and the OLIMEX SBW JTAG layout; we ship the boards with SMT jumpers which are shortened for the OLIMEX JTAG layout so if you use the TI JTAG, you should move the jumpers to TI positionMSP430-PIR board use ultralow-power mi…View Design
The MAX9926U evaluation kit (EV kit) is a fully assembled and tested circuit board that contains a dual-channel differential variable-reluctance (VR or magnetic pickup) sensor interface circuit using a MAX9926U IC in a 16-pin QSOP package.
The dual-channel interface circuit also features differential amplifiers for evaluating a pair of differential or single-ended VR sensor signals …